Sry for the caps,
I use Knoppix regularly and I try to download the latest version ASAP. I use a Linksys WUSB11 v2.6 device to connect to the internet. I have found this device works with MandrakeLinux 9.1 and Knoppix only, however, the latest version (11-03-2003). Does not work any more, it simply stops when it tries to autoconfigure, I found that I can unplug the card before boot, plug it back in after boot, and run the Netowrk Configure and it works, but this is a little inconvenient. So I was wondering if there's any way to fix this.
Note: I do know that multiple reboots a re required (usually) to get this working, I rebooted 5 times before finally unplugging the thing and then plugging it back in after startup. I am writing this from within knoppix now, but It shouldn't even need to be unplugged.
Also: I ran into this same problem when I tried a "real" hard drive install using the 3.3 09-05 release.
ProLabs 10GBase-TX SFP+ RJ-45 Copper Transceiver Module P/N: SFP-10GBASE-T-C NEW
$34.99
Genuine Cisco 74-7747-01 Cisco 10Gbps 10GBase-T Copper 100m RJ-45 X2-10GB-T
$74.99
New Sealed Cisco SFP-10G-LR 10GBASE-LR SFP Plug-in GBIC Transceiver module A
$15.80
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP, 1310nm, 2km, LC, MMF, IND
$175.00
Cisco GLC-LX-SM-RGD 1G SFP LX/LH 1310nm 10km LC SMF
$400.00
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$25.99
Cisco Nexus 96-Port 10G SFP+ Switch N9K-93128TX w/ 9K-M12PQ 12-Port 40G QSFP
$149.99
New Sealed Cisco GLC-TE 1000BASE-T RJ45 SFP Transceiver module *US Shipping*
$20.00