Sry for the caps,
I use Knoppix regularly and I try to download the latest version ASAP. I use a Linksys WUSB11 v2.6 device to connect to the internet. I have found this device works with MandrakeLinux 9.1 and Knoppix only, however, the latest version (11-03-2003). Does not work any more, it simply stops when it tries to autoconfigure, I found that I can unplug the card before boot, plug it back in after boot, and run the Netowrk Configure and it works, but this is a little inconvenient. So I was wondering if there's any way to fix this.
Note: I do know that multiple reboots a re required (usually) to get this working, I rebooted 5 times before finally unplugging the thing and then plugging it back in after startup. I am writing this from within knoppix now, but It shouldn't even need to be unplugged.
Also: I ran into this same problem when I tried a "real" hard drive install using the 3.3 09-05 release.
Cisco Nexus 96-Port 10G SFP+ Switch N9K-93128TX w/ 9K-M12PQ 12-Port 40G QSFP
$149.99
Cisco Catalyst C9200-48P-E 48-Port Managed Gigabit Ethernet PoE+
$550.00
Cisco Catalyst C9300-24UX-A 24 UPOE Switch 90 Day Warranty
$320.00
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig Copper UPOE Network Switch
$375.00
Genuine Cisco SFP-10G-SR Transceiver Module (10-2415-03)
$5.85
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco C3850-NM-4-10G 4 Port Network Exp.Module for 3850
$124.99
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$32.90
Cisco Catalyst C9300-48P-E 48-Port Gigabit PoE+ Network Switch w/ C9300-NM-4G
$749.95
Cisco WS-C2960X-48FPD-L 48 V07 POE+ GE+2 10G SFP+, LAN BASE 740W w/ C2960X-Stack
$99.95