Results 1 to 10 of 18

Thread: Can we speed up Network Manager?

Hybrid View

  1. #1
    Senior Member
    Join Date
    Jan 2011
    Posts
    242
    Quote Originally Posted by utu View Post
    Well, thank you all for your suggestions.
    What ? Deprive you of your learning opportunity ? In my book that's a cardinal sin.

    Besides, if I suggested that the best way of speeding up the Network Manager was to not run the Network Manager I'd have had klaus2008 down on my tail (http://www.knoppix.net/forum/threads...ot-in-Adrianne).

    Quote Originally Posted by utu View Post
    I found this nice Ubuntu How-To which helps a lot:
    http://ubuntuforums.org/showthread.php?t=684495
    Beat that.
    http://wiki.debian.org/WiFi
    http://wiki.debian.org/WiFi/HowToUse

    You managed to find a real hacker's hacker - he didn't mention /etc/networks/interfaces once ! You then come up with a solution that names your wireless interface eth1 instead of the usual wlan0. Extra marks.

    Here's what the Debian installer put in my /etc/networks/interfaces to bring up my wifi with WEP:

    Code:
    # The primary network interface
    allow-hotplug wlan0
    iface wlan0 inet dhcp
            # wireless-* options are implemented by the wireless-tools package
            wireless-mode managed
            wireless-essid MyEssid
            wireless-key1 **********
    It is my understanding that with this the most you would need in /etc/rc.local is:

    Code:
    ifup wlan0
    and you might not even need that.

    Ever since I first met the wonderful Network Manager, I've had a manual way of getting my wireless going just in case. I normally use WPA PSK2. If my WPA PSK2 configuration is hidden away in:

    Code:
    /etc/wpa_supplicant.conf
    Then I can start my wireless by hand with:

    Code:
    sudo wpa_supplicant -B -c/etc/wpa_supplicant.conf -iwlan0
    sudo dhclient
    How many sudos did you use ? BTW I don't think you need sudo in /etc/.rc.local.

    I found recently that I can combine the two approaches with:

    Code:
    # The primary network interface
    allow-hotplug wlan0
    iface wlan0 inet dhcp
        wpa-conf /etc/wpa_supplicant.conf
    The problem with the Network Manager is not just that it is started when your PC / LT is busy starting everything else, it's not just that the Network Manager is a big desktop app, it's not just that the LXNetMan is still 'in development'. It's that the Network Manager does not try to connect until you login in. This is not obvious with Knoppix but if you try it on a real desktop installation you'll see what I mean. Thus the Network Manager starts connecting very late in the startup sequence so it appears slower that Windoze.

    By connecting without the Network Manager, you starting connecting much earlier in the startup sequence. The cost is that you must already know which network you want to connect to. This may not be a concern to you but for those that carry their laptop round like security blankets and use them everywhere like they were mobiles (or handys or cells), this could be a real drawback.

    Enter wicd. This is a new, ligthweight, alternative to the Network Manager. It is not as flash as the Network Manager but I understand it will connect in both GUI and console modes. This leads me to believe it must be possible to start it much earlier in the start up sequence.

    I have it running on one Debian laptop but I don't have the time to experiment with it any further. You might like to. If your name is dinoesep, back up your knoppix-data.img first 'cos I think you'll need to uninstall Network Manager in order to install wicd. Obviously, start your network first !

    Cheers
    Last edited by Forester; 03-05-2011 at 01:45 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


ProLabs 10GBase-TX SFP+ RJ-45 Copper Transceiver Module P/N: SFP-10GBASE-T-C NEW picture

ProLabs 10GBase-TX SFP+ RJ-45 Copper Transceiver Module P/N: SFP-10GBASE-T-C NEW

$34.99



Dell EMC SFP-10G-T-MG-30M Reach On CAT6A/7 Transceiver WP2PP picture

Dell EMC SFP-10G-T-MG-30M Reach On CAT6A/7 Transceiver WP2PP

$199.99



NEW Open Box Dell PowerConnect M8024-SFP+ Quad Port 10GbE SFP Module 0N805D (BH) picture

NEW Open Box Dell PowerConnect M8024-SFP+ Quad Port 10GbE SFP Module 0N805D (BH)

$29.99



10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module picture

10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module

$85.00



Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm picture

Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm

$25.99



Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03  picture

Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03

$8.00



SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02 picture

SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02

$5.00



Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC picture

Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC

$10.99



New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module picture

New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module

$69.99



NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping* picture

NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*

$18.00