Sry for the caps,
I use Knoppix regularly and I try to download the latest version ASAP. I use a Linksys WUSB11 v2.6 device to connect to the internet. I have found this device works with MandrakeLinux 9.1 and Knoppix only, however, the latest version (11-03-2003). Does not work any more, it simply stops when it tries to autoconfigure, I found that I can unplug the card before boot, plug it back in after boot, and run the Netowrk Configure and it works, but this is a little inconvenient. So I was wondering if there's any way to fix this.
Note: I do know that multiple reboots a re required (usually) to get this working, I rebooted 5 times before finally unplugging the thing and then plugging it back in after startup. I am writing this from within knoppix now, but It shouldn't even need to be unplugged.
Also: I ran into this same problem when I tried a "real" hard drive install using the 3.3 09-05 release.
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch, no module
$299.97
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch + NM-8X Module
$599.97
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig Copper UPOE Network Switch
$375.00
Cisco WS-C3850-48T-S Catalyst 48-Port Managed Gigabit Ethernet Switch New Open B
$599.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ Lifetime Warranty
$85.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$32.90
Cisco Catalyst 2960 WS-C2960-48TC-S 48-Port 10/100 Managed Ethernet Switch
$28.00
Genuine Cisco 74-7747-01 Cisco 10Gbps 10GBase-T Copper 100m RJ-45 X2-10GB-T
$74.99
Cisco WS-C3850-24S-S 24 Port IP Base Switch - W/ 10G - Same Day Shipping
$499.99