Sry for the caps,
I use Knoppix regularly and I try to download the latest version ASAP. I use a Linksys WUSB11 v2.6 device to connect to the internet. I have found this device works with MandrakeLinux 9.1 and Knoppix only, however, the latest version (11-03-2003). Does not work any more, it simply stops when it tries to autoconfigure, I found that I can unplug the card before boot, plug it back in after boot, and run the Netowrk Configure and it works, but this is a little inconvenient. So I was wondering if there's any way to fix this.
Note: I do know that multiple reboots a re required (usually) to get this working, I rebooted 5 times before finally unplugging the thing and then plugging it back in after startup. I am writing this from within knoppix now, but It shouldn't even need to be unplugged.
Also: I ran into this same problem when I tried a "real" hard drive install using the 3.3 09-05 release.
VIntage Apple Macintosh LC III Computer - As Is Powers On
$49.99
Vintage Apple Macintosh II 2 M5000 Computer *Not Powering On* Clean Case
$295.00
Circuit board from Vintage Macintosh II Computer – UNTESTED
$49.99
Vintage Original 1st Edition Macintosh Portable M5126 Bag Wires Embossed Model #
$1299.99
Macintosh Accessory Kit Vintage Box 1991
$30.00
COMPLETE Vintage Apple Macintosh 512k M0001 E
$635.00
Vintage Apple Mac Sony MP-F75W-01G 2MB 3.5" Floppy Disk Drive
$58.00
Vintage Macintosh AppleColor High Resolution RGB Monitor M0401 Apple NO POWER
$79.00
Vintage Apple Macintosh Classic Model M0420 *Powers ON
$70.00
APPLE MACINTOSH SE FDHD All In One Vintage Computer - Model M5011 With BOX
$289.99