Sry for the caps,
I use Knoppix regularly and I try to download the latest version ASAP. I use a Linksys WUSB11 v2.6 device to connect to the internet. I have found this device works with MandrakeLinux 9.1 and Knoppix only, however, the latest version (11-03-2003). Does not work any more, it simply stops when it tries to autoconfigure, I found that I can unplug the card before boot, plug it back in after boot, and run the Netowrk Configure and it works, but this is a little inconvenient. So I was wondering if there's any way to fix this.
Note: I do know that multiple reboots a re required (usually) to get this working, I rebooted 5 times before finally unplugging the thing and then plugging it back in after startup. I am writing this from within knoppix now, but It shouldn't even need to be unplugged.
Also: I ran into this same problem when I tried a "real" hard drive install using the 3.3 09-05 release.
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$37.41
Juniper Networks EX3300 EX3300-48P PoE+ 48-Port 4x SFP Gigabyte Ethernet Switch
$59.99
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$168.00
Juniper EX4200-48PX 48-PORT 10/100/1000BASET PoE Ethernet Switch
$50.00
Juniper EX4500-40F-BF-C 40-Port 10Gbe SFP+ Switch
$124.99
Juniper Networks SRX650 Service Gateway Firewall Appliance W/ 2x PWS
$53.79
Juniper Networks SRX320-POE 6-Port Service Gateway Security Appliance Tested
$149.99
Juniper EX 4300 EX4300-48P Switch VC DAC Cables 21.4R3-S7 48 Port PoE
$250.00
(2) Juniper Networks EX2300 (EX2300-48P) 48 Ports Ethernet Switch+ Power Cord
$500.00