-
How do I enable touchpad-tapping?
Hello everyone. I am new in this forum. Knoppix is a great Linux distro. I write a software for an old computer, without mouse and keyboard - only with touchscreen (i think - it use the same drivers like touchpad, so I'm testing my application on laptop). But touchpad-tapping (i want to it mean click) i disabled. I have downloaded synaptics drivers from repositories, but it still not works. What I must do to enable it? Change something in /etc/X11/xorg.conf ? Thank you in advance, rr
-
Senior Member
registered user
[there is a emoticon on top which I can't remove]
There are two ways to go about this, as you have noted, one is to modify /etc/X11/xorg.conf. Because knoppix xorg.conf is script generated, you will have understand the needed syntax and as well as understand which script is the one generating it.
Alternatively, this is what I would do it. Firstly make sure you have this program 'synclient', check that it exists :-
( this will list all the available settings ).
If it does not exist, you would have to install xserver-xorg-input-synaptic.
After that go to /etc/X11/Xsession.d and add a file say '15x11-synaptics' with this content :-
Code:
#
synclient "TapButton1=1"
That's all which is needed. After you restarted Xserver, tap-to-click will be working.
Last edited by kl522; 09-27-2010 at 10:59 PM.
-
Senior Member
registered user
@kl522
Thank you for providing this valuable information.
I use the command
Code:
synclient TapButton1=1 TapButton2=3 TapButton3=2
to enable tapping with two and three fingers. Tapping with two fingers is set to button 3 because clicking with the right button is more often than clicking with the middle button.
-
thanks, it works
-
Senior Member
registered user
You are fully justified to use tap-to-click on a system without keyboard and mouse.
I use touchpad on a typical notebook, personally I consider tap-to-click a nuisance.
However I do this :-
synclient "HorizEdgeScroll=1"
to allow me to use horizontal scroll on the edge of the touchpad.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Altair 8800 CPU Board Working *TESTED* reproduction
$790.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$69.95
IMSAI 8080A MPU-A CPU Parts Kit Not Altair MITS (board NOT included)
$59.95
Vintage NorthStar Horizon HRAM 64k Dynamic RAM Board, S-100 IMSAI Altair
$125.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Altair MITS 8800 CPU Card 8080A S-100 S100 replica IMSAI CP/M
$35.00
1978 S-100 Bus Handbook MITS Altair Interfacing + Apple II Commodore PET TRS-80
$48.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
HyperWorks 2020 Suite for PC (Tool For Engineering Design, Simulation) 50Gb
$72.87
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$358.99