... if you are using Knoppix 6.2 there is a mistake in /etc/init.d/knoppix-autostart. Have a look at
http://www.wp-schulz.de/knoppix/uhrzeit.html
for more information (in german language written).
Greetings
Werner
I find that the time zone I set will not survive a reboot. I set the correct system time and time zone by typing 'sudo time-admin' in the lxterm. Then I type 'sudo hwclock -w' which I thought would save the settings after rebooting. However after booting I always have to reset the correct timezone again. This is necessary because I use Tor and it requires the correct time and timezone to work properly.
Any advice so I don't have to keep resetting?
... if you are using Knoppix 6.2 there is a mistake in /etc/init.d/knoppix-autostart. Have a look at
http://www.wp-schulz.de/knoppix/uhrzeit.html
for more information (in german language written).
Greetings
Werner
I am using 6.3 which I got from a magazine. Unfortunately I don't understand German.
# part of /etc/init.d/knoppix-autostart:
#
# Set timezone
KTZ="$(getbootparam tz)"
[ -n "$KTZ" ] || KTZ="$(getbootparam timezone)"
[ -n "$KTZ" -a "$KTZ" != "auto" ] && TZ="$KTZ"
if [ -n "$TZ" ]; then
echo "$TZ" > /etc/timezone
# this will remove /etc/localtime
rm -f /etc/localtime
# /usr/share/zoneinfo/localtime is a symlink to /etc/localtime
# but /etc/localtime doesn't exist any more.
# Therefore the second part of the if-loop will not work
[ -r /usr/share/zoneinfo/"$TZ" ] \
&& { cp -f /usr/share/zoneinfo/"$TZ" /etc/localtime; }
fi
If this mistake is also in Knoppix 6.3 you must uncomment the lines of the if-loop
Greetings
Werner
I have been fighting this for a week. Just found a solution: from root: 1)dpkg-reconfigure tzdata 2)date MMDDHHmmCCYY 3)hwclock --localtime 4)hwclock --systohc It survived a reboot. Take care.
"HD install" is for a few specific purposes (mostly re-mastering), but it isn't really that good for use as a "Linux system." Better to use the "Flash install", which avoids the "chroot'd environment" that causes so many anomalous characteristics not suitable for a working system. Clock changes as described should work better, too!
Cheers!
Krishna
I am definitely finding that to be the case, Krishna. I am a newbie. I have loaded Debian full, and PCLinuxOS. Since I am not in any real need for usage, just learning and playing around. I decided to stick with the HD install a bit longer. Hard to get around losing your word processor on a full upgrade.... still I think I will poke and prod a bit longer.
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
Samsung 16GB 2Rx4 PC4-2400 RDIMM DDR4-19200 ECC REG Registered Server Memory RAM
$20.99
8GB PC3L-12800S 1600MHz SODIMM DDR3 RAM | Grade A
$12.00
Kingston HyperX FURY DDR3 8GB 16GB 32G 1600 1866 1333 Desktop Memory RAM DIMM
$13.25
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
Corsair 32GB (4X8GB) DDR3 PC3-14900 1866 NON ECC LOW DENSITY CMT32GX3M4X1866C9
$32.00
Samsung 16GB (2x8GB) PC3L-12800S Lap Top Memory RAM
$20.00
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96
A-Tech 128GB 4x 32GB 2Rx4 PC4-21300R DDR4 2666 ECC REG RDIMM Server Memory RAM
$199.96